Easy to use injection moulding machine with temperature controlled heating barrel, rack and pinion injection ram and over centre mould closing. Wheel mould (flat upper and shaped lower mould) and 2Kg polystyrene granules are supplied.

The 180 cuts & sculpts expanded TP & bends sheet TP up to 6mm. The unit incorporates:180mm(7in) working length (cutting) 300mm(12in) working length (bending) 480mm(19in) throat depth. Work table calibrated in metric & imperial units 90, 67.5, 60 & 45 degree cutting angles. Foot switch virtually eliminates fumes

Operates on the hot wire principle, producing a precise line of heat that gives a sharp bend. Two power option with spring loaded work clamping and a quickly adjusted air gap. Will handle most common thermoplastics being able to bend sheet from 0.5 to 6mm thick.

Operates on the hot wire pricipal, producing a precise heat that gives a sharp bend. Heating wire protected by a clear plastic guard. Will bend sheets up to 500mm wide and 6mm thick.

Operates on the hot wire principal, producing a precise line of heat that gives a sharp bend. Two power option with spring loaded work clamping and a quickly adjusted air gap. Will handle most common thermoplastics, model 1000 has two heating wires being able to bend sheet up to 8mm thick and 1000mm wide.

The Hot Wire Sculptor 280 incorporates. 280mm(11in) cutting length. 635mm(25in) throat depth. Adjustable work guides for accurate material referencing. Robust polyethylene table. Wire bow protractor accurately sets angles, chamfers & cones. 5 cutting speeds. 3 sculpting speeds. Foot switch virtually eliminates fumes. Extended bow (1,000 mm [39.5 in]) is available.

With a pulling capacity of -0.83 bar this vacuum fomer moulds sheets up to 228 x 305mm. It is fitted with a rolling hood, a no-volt safety release switch and an interlock to prevent the platen being raised into the ceramic heaters.

With a pulling capacity of -0.83 bar this vacuum former moulds sheets up to 457 x 254mm. It is fitted with a rolling hood, ceramic heaters, a visual heater display mode and moulded silicone clamp seals.

For economy this reducing frame allows for smaller size plastic sheets to be used.

A kit for replacing the silicone seals on vacuum formers 917 and 725. Includes silicone seal, platen seal element and adhesive.