Front aluminium panel for the alubind project.
This piece needs no floding, but as the front piece provides the main opportunity for design. It's not a bad idea to complete the design work on the piece after drilling the 4 holes, but prior to joining. This makes it easier to work with.
How to order:
Fax your order to (02) 83234000
Or email your order to firstname.lastname@example.org
We will send the goods out with an invoice.
To make card payments please call 1300 363 352
Back aluminium panel for the alubind project comes with a protective sheet on one side.
Ready to use. Edges will need smoothing with wet and dry paper. mark out the fold line with a scribe and a steel rule. It turns out that the average steel rule is the exact width of the spine of the alubind so you can simply hold the steel rule along one long edge and scribe the fold line along it. No need for any measurement.
Aluminuim body used for the Ecolamp project. 600mm long.
This extrusion is designed to accept the ploypropylene cut to 30mm strips which cover up the cord and screws (if the base is back-fitting). The length is designed to make it easy to bend, but generally the lenght will be too long. Cut to size after bending with a junior hacksaw.
50mm diameter Aluminium pipe 600mm long.
Secure the bending bar in two bench vices and rress the Ecolamp body over the bending bar to achieve a curve. Care is needed so that it does not simply buckle. The best method is to make several small bends over an area.